fanzo Professional Electronics Expert Team

TypePS146/11G
Model: WA1442N
ART No.: 605897
Programator T75 Type2000 H2 u 2004/6582

Veš mašina povuče vodu i dalje ne reaguje kada stavim na centrifugu izbaci vodu i opet stoji a programator se čuje.
Znači motor se uopšte ne okreće. Skinuo sam ga proverio četkice, uključio ga na radnom stolu i motor radi.
Tahogenerator proveren ispravan. Mašina je pravljena za inostranstvo i pored PG programatora ima pločicu sa elektronikom.
Potrebna mi je šema veš mašine i šema programatora ili pomoć šta dalje da gledam?
Nisam par godina radio veš mašine....sad sam počeo ponovo.
Unapred Hvala za pomoć...

Proveri za pocetak trijak motora

A onaj žandar plavi kondenzator šta kaže ?

Ostavi artikal broj masina pa cu pronaci nesto od dokumenata ako postoje, cini mi se da je starija masina u pitanju, a 65 artikala sa tim brojem ima.

Pločicu sam dao elektroničaru.
Evo braca prilažem sliku sa podacima veš mašine.

Kolega, upisuj tražene oznake u post jer pretrage ne pronalaze slike.

Edit: dopisano u prvi post teme.

Nazalost proizvedena je pre 1999. godine i nema neka konkretna pomoc u katalogu Gorenja.

Citiram samo ovo sto sam nasao

SERVICING INSTRUCTIONS FOR WASHING MACHINES WITH HYBRID TIMER
AKO (PS 145/…, PS 146/… (1200 – 1500 rpm in spin))
Washing machines with spinning speed of 1200 – 1500 r.p.m., hybrid timer AKO (Code No.617040) and electronic control (Code No.617041 resp. one-way control 617042) have installed servicing diagnostics. In the event of certain fault (faults are stated in enclosure, chart 1) the machine can respond in different ways – most frequently the electronic control turns timer to position 58, being the position of fault. In this way the customer sees that something is wrong and calls for the repair. Since these machines do not have the fault display (on the basis of which the customer could state the kind of fault), there is a test program that enables the definition of the
fault.
You need the test connector (it can be ordered under Code No.505961) with LED-diode which is to be set to electronics (see circuit diagram – contacts T4.1-T4.4). It is essential that the machine is empty, program set to position A and/or 1 (pre-wash cottons – see time diagram) and machine turned ON. Washing machine will perform the test program, lasting approximately 7 minutes. During the test program diode flashes at frequency rate of 1 Hz (1x per second). If fault does not turn up during test program, the diode will be flashing in the end at frequency rate of 0,5 Hz (2x per second). However, if the fault turns up, the machine will respond in the manner described in enclosure, Chart 2, diode flashes in compliance with the fault number with intermediary intervals. The kind of fault can be defined by counting up the number of flashes.