BEKO GNE15906S

Forum za frižidere i zamrzivače.

Urednici: goranfri,nike,sim,Honorarac

Pravila foruma
BT-expert info - BTexpert forumi
U naslov teme prvo pisati ime proizvođača, zatim oznake modela bez crtica i razmaka i kratak opis kvara. U post obavezno upisati ID ili EAN oznake sa poleđine aparata u suprotnom tema će biti obrisana.
Praktikujemo da na kraju opišemo kako smo rešili problem. Zatim zatvorimo temu >UPUTSTVO<
PRILIKOM POSTAVLJANJA PITANJA U VEZI ELEKTRONSKOG MODULA OBAVEZNO POPIŠITE SVE OZNAKE sa ploče i sa nalepnica, dobro bi došla i po koja fotografija.
Avatar
kibsa
_
_
Postovi: 194
Pridružen: 16 Nov 2006, 01:11
Lokacija: BiH

BEKO GNE15906S

Post napisao kibsa » 26 Jun 2017, 07:05

MODEL: GNE15906S
CLASS: SN-T
TIP: I
PRODUCT NUMBER: 7218848785
Motor: EGZS90HLC; R134a
Elektronski modul: ARCELIK, KAREL HBDK00437-AAG
REV:MARB30A-AAGAAG-AAD,
S/N: 51693252082109,
P/N: 4334580185
Fižideru (u naslovu teme) je probio grijač za otapanje leda na isparivaču, a na displeju ispisuje EROR 04. Nakon zamjene grijača frižider postigne teperaturu -24 stepena, ali ne isključuje motor. Da li neko može pomoći i reći na šta ukazuje ispisana greška i na koji se način resetuje .
Zadnja izmena: kibsa, dana 29 Jun 2017, 10:07, ukupno menjano 2 puta.

Avatar
sim
gxu
gxu
Postovi: 1114
Pridružen: 09 Jul 2009, 21:43
Location: Krusevac
Warranty service: Bela tehnika
Contact person: Ivan
Phone number: 0038162303936
Specialty: whitegoods

Re: BEKO GNE15906S

Post napisao sim » 27 Jun 2017, 01:35

U naslov teme prvo pisati ime proizvođača, zatim oznake modela bez crtica i razmaka i kratak opis kvara. U post obavezno upisati ID ili EAN oznake sa poleđine aparata u suprotnom tema će biti obrisana.

Napisi produkt broj 72.......


Za neki MOZDA slican tvome(7219945781):

E4 (Defrost heater failure):
- Entry: If defrost time is equal to the maxi
mum defrost time of 60
min. for 3 consecutive
defrosts this error is shown.
- Behaviour during error: Control runs defrost heater normally.
- Exit: When a defrost finishes shorter than maximum time of 60min error is omitted.

When the failure is corrected the error code will disappear on the display and control will run
according to normal related algorithm.
After a power interruption, erro
r codes should be remembered.
After an initial power-up, error codes, except he
ater error, should not
be remembered. (Heater
error should be remembered)
Error codes are cleared
after a self-test.

During the first 30 sec of power
interruption or initial powe
r up, the service test may be
initiated by pressing the Light a
nd Ice-off buttons together for
3 sec
.
For
0,5sec
, all segments and the buzzer are ON.
Afterwards all segments and the buzzer are OFF for
0.5sec
.
Above loop continuous until
any button is pressed.
When any button is pressed, freezer set point
digits show the version number, in decimal
notation (such as 01, ...05, etc) for
3
sec
. At this time, fridge se
gment shows revision number
in decimal notation (such as 1,...5, etc). Vers
ion number shows important modification in
Software, revision number shows any small modifications.
Then the sensor temperatures displayed according to the below sequence:
- Freezer temperature displayed on freezer display, and fridge display shows “r” for
2 sec.
- Fridge temperature displayed on freezer di
splay, and fridge display shows “F” for
2 sec.
- Evaporator temperature displayed on freezer
display, and fridge display shows “d” for
2 sec
.
- Ice sensor temperature displayed on freezer
display, and fridge display shows “I” for
2 sec
.
Above sensor temperature displaying
continues until any
button is pressed.
When any button is pressed, then the freezer di
splay shows “--“ and the fridge display shows
“-“.
SIMkom

Avatar
kibsa
_
_
Postovi: 194
Pridružen: 16 Nov 2006, 01:11
Lokacija: BiH

Re: BEKO GNE15906S

Post napisao kibsa » 27 Jun 2017, 06:55

Hvala Sim, danas ću probati da odem pokupiti podatke i da pokusam reset, javljam se uskoro.

Avatar
kibsa
_
_
Postovi: 194
Pridružen: 16 Nov 2006, 01:11
Lokacija: BiH

Re: BEKO GNE15906S

Post napisao kibsa » 29 Jun 2017, 10:10

Uspio sam poništiti grešku br 4. stiskanjem prvog i trećeg tastera zajedno, ali i dalje se frižider ne isključuje ni na -24 stepena iako je podešena temp. -18 stepeni.

Odgovori
  • Slične teme
    Odgovori
    Pregledano
    Zadnji post

Natrag na “FRIŽIDERI I ZAMRZIVAČI”