fanzo Professional Electronics Expert Team

Pozdrav kolege!

Evo me opet nakon dugo vremena. Odmakao sam se od popravaka kućanske elektronike pa me nije dugo bilo. Ženina sestra je izgleda malo forsirala indukciju pred Uskrs :) Pojavila se greška E4. Opis stoji "Greška u konfiguraciji ploče za kuhanje". Ima 2 "ringle" i samo veća joj ne radi. Odnosno kad pokuša uključiti veću, ova greška se pojavi. Da li imao netko kad ovakav problem? O čemu se tu zapravo radi? I naravno kako se otkloni greška?
Ja sam pretražio po internetu kakve to mogu biti konfiguracije i slično, ali nikakvih korisnih informacija. A moja 3-4 popravka indukcija mi ne daju ni blizu dovoljno iskustva da sam zaključim.

Hvala i srećan Uskrs!!!!

CONFIGURATION OF DOMINO BASIC INDUCTION
Configuring is necessary when changing the IHE (induction heating element), or when the display shows E4.
Procedure is the following:
Hob shall be switched off.
Press and hold the sensor key Stop/go (second from the right) and successively press the three left sensor keys (in the sequence: timer, "-", "+"). Sound signal is heard at each press.
Display shows C (flashing) and 0. Hob locking sensor diode flashes, too. Press again and hold the key Stop/go until sound signal is heard i.e. display shows “C” for non-configured and “-" for configured cooking zone.
Put a pot on non-configured coking zone and press sensor key "+" for this zone. “C” changes into "-".
The above mentioned procedure shall be carried out for each cooking zone until the configuration menu after the configuration of the last cooking zone automatically terminates.

ATTN: how to reset the configuration?
When inside the configuration menu (configured and non-configured IHE are shown), it is necessary to press one of sensor keys “minus” for a few seconds (sound signal is heard). “E” will flash on displays for some time, and then two “C” appear. Now configuration can be carried out again.

Mozda pomogne.