MODEL: GNE15906S
CLASS: SN-T
TIP: I
PRODUCT NUMBER: 7218848785
Motor: EGZS90HLC; R134a
Elektronski modul: ARCELIK, KAREL HBDK00437-AAG
REV:MARB30A-AAGAAG-AAD,
S/N: 51693252082109,
P/N: 4334580185
Fižideru (u naslovu teme) je probio grijač za otapanje leda na isparivaču, a na displeju ispisuje EROR 04. Nakon zamjene grijača frižider postigne teperaturu -24 stepena, ali ne isključuje motor. Da li neko može pomoći i reći na šta ukazuje ispisana greška i na koji se način resetuje .
BEKO GNE15906S
Urednici: goranfri,nike,Honorarac,sim
Pravila foruma
BT-expert info - BTexpert forumi
U naslov teme prvo pisati ime proizvođača, zatim oznake modela bez crtica i razmaka i kratak opis kvara. U post obavezno upisati ID ili EAN oznake sa poleđine aparata u suprotnom tema će biti obrisana.
Praktikujemo da na kraju opišemo kako smo rešili problem. Zatim zatvorimo temu >UPUTSTVO<
PRILIKOM POSTAVLJANJA PITANJA U VEZI ELEKTRONSKOG MODULA OBAVEZNO POPIŠITE SVE OZNAKE sa ploče i sa nalepnica, dobro bi došla i po koja fotografija.
BT-expert info - BTexpert forumi
U naslov teme prvo pisati ime proizvođača, zatim oznake modela bez crtica i razmaka i kratak opis kvara. U post obavezno upisati ID ili EAN oznake sa poleđine aparata u suprotnom tema će biti obrisana.
Praktikujemo da na kraju opišemo kako smo rešili problem. Zatim zatvorimo temu >UPUTSTVO<
PRILIKOM POSTAVLJANJA PITANJA U VEZI ELEKTRONSKOG MODULA OBAVEZNO POPIŠITE SVE OZNAKE sa ploče i sa nalepnica, dobro bi došla i po koja fotografija.
BEKO GNE15906S
Zadnja izmena: kibsa, dana 29 Jun 2017, 10:07, ukupno menjano 2 puta.
- sim
- gxu
- Postovi: 1117
- Pridružen: 09 Jul 2009, 21:43
- Location: Krusevac
- Warranty service: Bela tehnika
- Contact person: Ivan
- Phone number: 0038162303936
- Specialty: whitegoods
Re: BEKO GNE15906S
U naslov teme prvo pisati ime proizvođača, zatim oznake modela bez crtica i razmaka i kratak opis kvara. U post obavezno upisati ID ili EAN oznake sa poleđine aparata u suprotnom tema će biti obrisana.
Napisi produkt broj 72.......
Za neki MOZDA slican tvome(7219945781):
E4 (Defrost heater failure):
- Entry: If defrost time is equal to the maxi
mum defrost time of 60
min. for 3 consecutive
defrosts this error is shown.
- Behaviour during error: Control runs defrost heater normally.
- Exit: When a defrost finishes shorter than maximum time of 60min error is omitted.
When the failure is corrected the error code will disappear on the display and control will run
according to normal related algorithm.
After a power interruption, erro
r codes should be remembered.
After an initial power-up, error codes, except he
ater error, should not
be remembered. (Heater
error should be remembered)
Error codes are cleared
after a self-test.
During the first 30 sec of power
interruption or initial powe
r up, the service test may be
initiated by pressing the Light a
nd Ice-off buttons together for
3 sec
.
For
0,5sec
, all segments and the buzzer are ON.
Afterwards all segments and the buzzer are OFF for
0.5sec
.
Above loop continuous until
any button is pressed.
When any button is pressed, freezer set point
digits show the version number, in decimal
notation (such as 01, ...05, etc) for
3
sec
. At this time, fridge se
gment shows revision number
in decimal notation (such as 1,...5, etc). Vers
ion number shows important modification in
Software, revision number shows any small modifications.
Then the sensor temperatures displayed according to the below sequence:
- Freezer temperature displayed on freezer display, and fridge display shows “r” for
2 sec.
- Fridge temperature displayed on freezer di
splay, and fridge display shows “F” for
2 sec.
- Evaporator temperature displayed on freezer
display, and fridge display shows “d” for
2 sec
.
- Ice sensor temperature displayed on freezer
display, and fridge display shows “I” for
2 sec
.
Above sensor temperature displaying
continues until any
button is pressed.
When any button is pressed, then the freezer di
splay shows “--“ and the fridge display shows
“-“.
Napisi produkt broj 72.......
Za neki MOZDA slican tvome(7219945781):
E4 (Defrost heater failure):
- Entry: If defrost time is equal to the maxi
mum defrost time of 60
min. for 3 consecutive
defrosts this error is shown.
- Behaviour during error: Control runs defrost heater normally.
- Exit: When a defrost finishes shorter than maximum time of 60min error is omitted.
When the failure is corrected the error code will disappear on the display and control will run
according to normal related algorithm.
After a power interruption, erro
r codes should be remembered.
After an initial power-up, error codes, except he
ater error, should not
be remembered. (Heater
error should be remembered)
Error codes are cleared
after a self-test.
During the first 30 sec of power
interruption or initial powe
r up, the service test may be
initiated by pressing the Light a
nd Ice-off buttons together for
3 sec
.
For
0,5sec
, all segments and the buzzer are ON.
Afterwards all segments and the buzzer are OFF for
0.5sec
.
Above loop continuous until
any button is pressed.
When any button is pressed, freezer set point
digits show the version number, in decimal
notation (such as 01, ...05, etc) for
3
sec
. At this time, fridge se
gment shows revision number
in decimal notation (such as 1,...5, etc). Vers
ion number shows important modification in
Software, revision number shows any small modifications.
Then the sensor temperatures displayed according to the below sequence:
- Freezer temperature displayed on freezer display, and fridge display shows “r” for
2 sec.
- Fridge temperature displayed on freezer di
splay, and fridge display shows “F” for
2 sec.
- Evaporator temperature displayed on freezer
display, and fridge display shows “d” for
2 sec
.
- Ice sensor temperature displayed on freezer
display, and fridge display shows “I” for
2 sec
.
Above sensor temperature displaying
continues until any
button is pressed.
When any button is pressed, then the freezer di
splay shows “--“ and the fridge display shows
“-“.
SIMkom
Re: BEKO GNE15906S
Hvala Sim, danas ću probati da odem pokupiti podatke i da pokusam reset, javljam se uskoro.
Re: BEKO GNE15906S
Uspio sam poništiti grešku br 4. stiskanjem prvog i trećeg tastera zajedno, ali i dalje se frižider ne isključuje ni na -24 stepena iako je podešena temp. -18 stepeni.
-
- Slične teme
- Odgovori
- Pregledano
- Zadnji post
-
- 19 Odgovori
- 3135 Pregledano
-
Zadnji post napisao Frigomajstor
18 Okt 2015, 23:45
-
- 10 Odgovori
- 1374 Pregledano
-
Zadnji post napisao nike
17 Sep 2016, 13:51
-
-
Frizider Beko ledi-ne otapa zadnju plocu
napisao vaca87 » 19 Jul 2017, 20:53 » u FRIŽIDERI I ZAMRZIVAČI - 6 Odgovori
- 17458 Pregledano
-
Zadnji post napisao vaca87
17 Jan 2018, 23:26
-
-
-
beko model CSA 30010,potreban podatak za kompresor na R600a.
napisao alexb » 26 Avg 2017, 20:43 » u FRIŽIDERI I ZAMRZIVAČI - 13 Odgovori
- 2754 Pregledano
-
Zadnji post napisao nike
06 Sep 2017, 21:24
-
-
- 8 Odgovori
- 4086 Pregledano
-
Zadnji post napisao nike
05 Dec 2019, 21:17
-
-
Kombinovani frižider BEKO DSA33010 zviždi
napisao Kole » 24 Apr 2020, 09:05 » u FRIŽIDERI I ZAMRZIVAČI - 7 Odgovori
- 2350 Pregledano
-
Zadnji post napisao frigoservisbata
27 Apr 2020, 13:19
-
-
-
Beko RFSA 240 M21 W, pojacan zvuk nakon ukljucivanja
napisao alexb » 05 Nov 2021, 13:31 » u FRIŽIDERI I ZAMRZIVAČI - 6 Odgovori
- 918 Pregledano
-
Zadnji post napisao miodrag popovic
05 Nov 2021, 22:10
-